EPDM vs GRP vs felt comes down to budget, lifespan and how the roof will be used. Torch-on felt is the cheapest, at around £50 to £90 per m², and lasts 15 to 25 years. EPDM rubber costs around £80 to £120 per m² and lasts 25 to 35 years. GRP fibreglass costs around £90 to £140 per m², lasts 25 to 30 years and handles foot traffic best. These 2026 figures come from Trade2Base’s flat roof cost guide.
All three can give you a watertight flat roof if they are installed properly. This guide compares EPDM vs GRP vs felt side by side so you can choose the right system for an extension, garage, dormer or balcony.
EPDM vs GRP vs Felt: Side-by-Side Comparison
| Torch-on felt | EPDM rubber | GRP fibreglass | |
|---|---|---|---|
| Typical cost per m² (2026) | £50–£90 | £80–£120 | £90–£140 |
| Small extension or garage (~18m²) | £1,200–£1,900 | £1,700–£2,600 | £1,900–£2,900 |
| Typical lifespan | 15–25 years | 25–35 years | 25–30 years |
| Seams | Several overlapping layers | Often a single sheet | Seamless |
| Installation | Heat (torch) applied | Cold applied | Cold applied, needs dry, mild weather |
| Foot traffic | Moderate | Light | Good |
| Repairs | Easy to patch | Quick patch or sealant repairs | Patchable, but needs sanding, new mat, resin and topcoat |
| Main weakness | Shorter life, more seams | Punctures, can shrink if not maintained | Rigid, can crack if the building moves |
| Look | Mineral or plain finish | Plain black rubber | Clean, seamless, range of colours |
Costs and lifespans are supply-and-fit figures from Trade2Base’s 2026 guide; repair, weakness and appearance rows are from Roofing Superstore’s GRP or EPDM guide (February 2026). Small roofs often cost more per m² because of fixed costs, and London prices tend to be higher.

Torch-On Felt Flat Roofs
Torch-on felt is the most affordable modern flat roof system. Layers of reinforced bitumen membrane are bonded to the roof deck and each other with a gas torch. Modern polyester-reinforced felts are far more durable than the old felt roofs many people remember, and a good three-layer system sits at the top of the 15 to 25 year range.
- Pros: lowest cost, quick to install, easy to repair, widely used on UK extensions and garages
- Cons: shorter lifespan than EPDM or GRP, more seams, and the naked flame means installers must take care around timber and eaves
EPDM Rubber Flat Roofs
EPDM is a synthetic rubber membrane, usually laid as one single sheet and bonded to the deck with adhesive. With no joints across the main roof area, there are few places for water to get in.
- Pros: long lifespan, cold applied with no flame, flexible as temperatures change, few or no seams
- Cons: corners and upstands are hand-formed so can look less crisp, and a thin or poorly fitted membrane will underperform
GRP Fibreglass Flat Roofs
GRP, or glass reinforced plastic, is a fibreglass mat set in resin on site and finished with a topcoat. It cures into a hard, seamless shell.
- Pros: seamless, hard-wearing, handles foot traffic well and gives a neat finish at edges, which makes it popular for balconies and walk-on roofs
- Cons: it is rigid, so it needs a very stable deck, and it must be laid in dry weather above a minimum temperature
Not sure which flat roof suits your extension? JW Roofing Solutions will look at your roof and recommend the right system for it, not a one-size-fits-all answer. Call +44 7467 800002 or request a free quote.
EPDM vs GRP: Which Is Better?
In the EPDM vs GRP decision, neither is better in every case. EPDM is usually the better choice for roofs that see little foot traffic and may move slightly, such as garages and rear extensions, because the rubber flexes and is cold applied. GRP is usually better for roofs that will be walked on, such as balconies and terraces, or where a crisp, hard finish matters. Both outlast traditional felt.

EPDM vs GRP Cost: Which Is Cheaper?
EPDM is usually the cheaper of the two. Supplied and fitted, EPDM runs at around £80 to £120 per m² against £90 to £140 per m² for GRP (Trade2Base, 2026). Roofing Superstore explains why: GRP needs more specialist resins, catalysts and tools, and should be laid by an experienced installer. The trade-off is that a well-laid GRP roof is less likely to need repairs, while EPDM is simpler and quicker to fit. A GRP quote far below an EPDM quote for the same roof is worth questioning.
Why Do GRP Roofs Leak?
GRP roofs usually leak because of how or where they were laid. GRP is rigid, so it can crack if the building or deck underneath moves, and it must be laid in completely dry weather; resin applied to a damp deck or in rain may not cure properly. It also expands and contracts with temperature, which is why Roofing Superstore notes it suits smaller roofs better.
Can You Walk on a GRP or EPDM Flat Roof?
GRP is the better choice for regular foot traffic because it cures into a hard, rigid surface, which is why it is used on balconies and terraces. EPDM is softer and can be damaged by punctures and high footfall, so it suits roofs that are only walked on for maintenance. For any flat roof, walking on it safely depends on the deck as much as the covering; our guide to walking on a flat roof covers what to check first.
Repairing EPDM, GRP and Felt Roofs
Small holes and tears in EPDM can usually be patched quickly or sealed. GRP can also be patch repaired, but the area has to be sanded back and rebuilt with new chopped strand mat, resin and a topcoat, so it takes more skill. Torch-on felt is the easiest of the three to repair locally. In the UK, most flat roof patch repairs cost £200 to £600 (MyJobQuote, September 2026); see our flat roof repair cost guide, our guide to ponding on a flat roof and our leaking roof repair cost guide for more.
Which Flat Roof Is Best for Your Project?
| Project | Often a good fit | Why |
|---|---|---|
| Garage or shed roof on a budget | Torch-on felt | Lowest cost, quick to fit |
| Single-storey rear extension | EPDM or felt | Long life, few seams, flexible |
| Dormer roof | EPDM or felt | Handles small, awkward areas well |
| Balcony or walk-on terrace | GRP | Hard-wearing, seamless finish |
| Roof with lots of detailing or upstands | Felt or GRP | Neater edges and detailing |
Whatever you choose, installation quality matters more than the material. Ask what guarantee comes with the roof; our guide to roof guarantees explains what to look for, and our flat roof repair guide covers when an existing roof can be repaired instead.
Blisters and bubbles in felt are one of the most common flat roof faults; our guide to flat roof blistering explains what causes them and when a blister needs repairing.
Frequently Asked Questions
Is EPDM or GRP better for a flat roof?
EPDM is usually better for roofs with little foot traffic, such as garages and extensions, because it is flexible and cold applied. GRP is usually better for balconies and walk-on roofs because it is hard-wearing and seamless.
How long does a felt flat roof last?
A modern torch-on felt flat roof typically lasts 15 to 25 years, with good three-layer systems towards the top of that range.
How much does an EPDM roof cost in the UK?
EPDM rubber roofing typically costs £80 to £120 per square metre supplied and fitted in 2026, or around £1,700 to £2,600 for a small extension or garage.
Which flat roof lasts the longest?
EPDM usually lasts the longest, at around 25 to 35 years, with some premium membranes quoted at up to 50. GRP lasts around 25 to 30 years, and felt 15 to 25.
Can you put EPDM or GRP over an old felt roof?
Sometimes, if the existing deck is sound and dry, but many roofers strip the old felt to check the deck first. A roofer should inspect the roof before recommending an overlay.
Is GRP more expensive than EPDM?
Usually, yes. GRP costs around £90 to £140 per m² fitted against £80 to £120 for EPDM, because it needs more specialist materials, tools and skill to lay.
Why do GRP roofs crack?
GRP is rigid, so it can crack if the deck or building underneath moves. Laying it in damp weather or on a poorly prepared deck also leads to early failures.
Get Expert Flat Roof Advice in SouthWest London
JW Roofing Solutions installs and repairs flat roofs across SouthWest London using torch-on felt systems and liquid roofing. We will look at your roof, explain the options honestly, including how they compare with EPDM and GRP, and give you a clear, written quote with no obligation. Call +44 7467 800002, get in touch online or see our flat roofing service.
Need help with your roof? JW Roofing Solutions provides flat roofing in SouthWest London. Get a free, no-obligation quote.




